10
Calder Brothers Corp
V1.0
Serial Number Range:
848-S-56TCG9Y2*03848 to _____________
Page 10
Model: 1560 Paver
Material Feed Controls
4.0 TWO SPEED
CAUTION: INJURY/OR DAMAGE MAY OCCUR: When switching to high range, bring
paver to a stop before switching. To engage from low to high ip the High range switch up.
MATERIAL FEED OPERATION
The 1560 allows you to congure the auger and conveyor operation of the paver for
both an Automatic mode and a Manual mode. Use the automatic mode whenever pos-
sible to increase the useful life of the feed augers, and to maintain a more consistent
“Head of Material” in front of the screed. In either mode the lower selector switch can
be set to “IN” for reverse material ow.
Figure A
SETUP
Each side of the paver must be set independently.
AUTOMATIC FEED OPERATION
1. Go to the LH operators’ station
To Next Page
Loading...