22
Calder Brothers Corp
V1.0
Serial Number Range:
848-S-56TCG9Y2*03848 to _____________
Page 22
Model: 1560 Paver
1. Engine Primary Element
a. Unbuckle clips to remove element container end cap.
b. Pull gently to remove main element.
c. Use compressed air with an element-cleaning nozzle
IMPORTANT: Main element should be replaced after six cleanings or 500 hours use.
IMPORTANT: Do not attempt to clean element using a standard air nozzle. Do not strike element on a
hard surface. Either action will damage the element.
Battery
CAUTION: BATTERY ELECTROLYTE IS A CAUSTIC ACID. KEEP IT AWAY FROM SKIN AND
EYES.IF CONTACT OCCURS, FLUSH THE
AFFECTED AREA WITH LOTS OF WATER.
CAUTION: DISCONNECT GROUND CABLE FROM THE NEGATIVE BATTERY POST BEFORE
ATTEMPTING TO SERVICE OR REMOVE
BATTERY.
1. Removal
a. Open engine compartment and locate battery to your near left side.
b. Disconnect ground (negative) cable from battery (-) terminal.
c. Disconnect positive cable from battery (+) terminal.
2. Cleaning
a. Remove battery, following correct procedures.
b. Thoroughly clean terminals with a battery-cleaning tool.
c. Mix a paste solution of baking soda and water and apply to battery and terminals.
d. Rinse battery and paver area near battery liberally with water.
3. Installation
a. Clean battery, following correct procedures.
b. Be certain battery area is clean and clear of debris.
c. Install battery and connect positive (+) cable to terminal.
To Next Page
Loading...