27
Calder Brothers Corp
V1.0
Serial Number Range:
848-S-56TCG9Y2*03848 to ________________
Page 27
Model: 1560 Paver
WARNING: THE TROUBLESHOOTING CHART AND PROCEDURES OUTLINED
IN THIS SECTION SHOULD NOT BE ATTEMPTED BY OTHER THAN EXPERIENCED
MECHANICS OR PERSONNEL UNDER THE DIRECT SUPERVISION OF AN EXPE-
RIENCED MECHANIC. FAILURE TO COMPLY MAY RESULT IN DAMAGE TO EQUIP-
MENT AND/OR INJURY OR DEATH TO PERSONNEL.
DANGER: RELEASE, RESTRAIN, OR OTHERWISE RENDER SAFE ALL POTENTIAL HAZARD-
OUS STORED OR RESIDUAL ENERGY. IF A POSSIBILITY EXISTS FOR REACCUMULATION OF
HAZARDOUS ENERGY, REGULARLY VERIFY DURING THE SERVICE AND MAINTENANCE THAT
SUCH ENERGY HAS NOT REACCUMULATED TO HAZARDOUS LEVELS.
DANGER: DO NOT RELEASE OR OPEN ANY HOSE OR HYDRAULIC CIRCUIT WHILE ANY IM-
PLMENT IS SUSPENDED IN THE AIR. ENSURE ALL IMPLMENTS ARE PROPERLY SUPPORTED
AND/OR IN THEIR DOWN MOST LOWEST POSITION.
A. Engine
For engine troubleshooting see charts indicating faults and recommended repair proce-
dures, refer to Manufacturer’s Operation and Maintenance Manual.
If your particular problem is not covered or you are unsure of what steps to take, contact
your dealer for assistance.
B. Transmission
1.Vehicle fails to move under power. Inadequate oil level in hydraulic reservoir.
Damaged wiring loom to steering station
Driveline mechanical failure
2. Vehicle moves in neutral.
Steering levers are actually engaged
Steering calibration adjustment required, (must be performed by authorized Mauldin ser-
vice technician)
For detailed troubleshooting information on hydrostatic transmission, refer to Trouble
Shooting Manual, Rexroth
Hydrostatic Transmissions, available from a Rexroth representative or dealer.
To Next Page
Loading...