Need help?Do you have a question about the Max CN55 and is the answer not in the manual?
General| Power Source | Pneumatic |
|---|---|
| Magazine Capacity | 300 nails |
| Nail Type | Coil |
| Operating Pressure | 70-120 PSI |
| Wire Gauge | 0.083" (2.1mm) |
Identifies and describes the individual components of the pneumatic nailer as shown in Fig.1.
Details product numbers, dimensions, weight, loading capacity, and air consumption for different models.
Outlines nail length, shank type, head diameter, and collation angle for compatible fasteners for each model.
Provides A-weighted sound power and pressure levels for various tool models according to EN12549.
Details the vibration characteristic values for different tool models as per ISO 28927-13.
Lists the common uses for the pneumatic nailer, such as pallet making and general construction.
Explains how to determine the production year from the product's serial number.
Specifies the correct N.P.T. male plug sizes and requirements for air fittings on different models.
Defines the recommended and maximum operating air pressure range for optimal tool performance and safety.
Details the required minimum diameter and maximum length for the air supply hose.
Emphasizes using clean, regulated compressed air and outlines precautions for regulator failure.
Advises using an air filter, regulator, and oiler for optimized performance and tool longevity.
A checklist covering safety gear, air supply, tool inspection, and leakage tests before use.
Step-by-step guide on how to open the magazine and load nails correctly into the tool.
Instructions for verifying tool functionality and adjusting air pressure before actual use.
Explains the two actuation modes (Contact and Sequential) and how to operate the tool.
Instructions for loosening, adjusting, and tightening the exhaust cover for preferred air direction.
Safety warnings and procedures for safely clearing jammed nails from the tool nose and magazine.
To Next Page
