22
2 This dial allows you to adjust wire tension
torque slightly.
To increase the tension, turn it in the coun-
terclockwise.
To decrease the tension, turn it in the clock-
wise.
3 Insert the charged battery pack into the tool
until a click is heard.
• When setting the main switch to ON, abso-
lutely do not bring your hand close to the
binding part or rotating part of the tip of the
tool.
4 Set the Trigger Lock to UNLOCK and turn on
the main switch.
5 Test the tool again to check the tie strength.
6 If the tie strength is not appropriate, repeat
procedures 1~5.
Torque dial
WARNING
Appropriate
Reinforcing bars Over-tightened
To Next Page
Loading...
Need help?
General
