21
3 Slide the Reel stopper to release the Reel
holder and remove the Tie-Wire.
4 Mount the new Tie-Wire. (Refer to the Tie-
Wire mounting method explanation.)
When the Tie-Wire runs out of binding wire
There should be around 12" (300 mm) of the Tie-
Wire left at end of the spool. This should be dis-
charged with the old spool and be replaced with
a new one.
3. Auto Power-off feature
This Re-bar Tier have "Auto Power-off" fea-
ture, which saves the power consumption of
the Li-ion battery when the tool is not operat-
ed.
If the tool is not operated for 30 minutes, the tool
is automatically turned off. This is "Auto Power-
off".
When the power is turned off automatically, turn
the main switch OFF, then turn ON the switch
again to operate the tool.
4. Tension adjustment
1 Be sure to turn the Main switch OFF, to lock
the Trigger and detach the Battery pack.
Reel
stopper
Tie-Wire
OFF
To Next Page
Loading...
Need help?
General
