To Next PageTo Next Page
Need help?Do you have a question about the Max TA551B/16-11 and is the answer not in the manual?
General| Operating Pressure | 70-100 psi |
|---|---|
| Air Inlet | 1/4 inch NPT |
| Magazine Capacity | 150 staples |
| Fastener Type | Staples |
| Applicable Staples | 16 gauge |
General safety precautions before using the tool, including reading the manual and keeping instructions.
Mandatory eye protection due to dust and fastener hazards during operation.
Tool must only be operated with compressed air, not other gases, due to explosion risk.
Recommended operating pressure is 70-100 p.s.i. (5-7 bar); do not exceed 120 p.s.i. (8 bar).
Ensure discharge outlet is on work surface to prevent fastener hazards.
Prohibits use of fastener driving tools on scaffoldings and ladders.
Avoid operating tool near flammable materials like thinner or gasoline.
Do not use tool where sparks could ignite atmospheric gases or dust.
Only touch trigger when intending to drive a fastener; avoid carrying tool with trigger pulled.
Never point the tool's discharge outlet at yourself or others to prevent accidents.
Specifies the ideal operating pressure range for optimal fastener performance.
Warning against using power sources other than compressed air.
Guidance on setting and maintaining the correct air pressure for operation.
Caution against operating the tool near flammable substances due to explosion risk.
Reinforces wearing eye protection and keeping hands away from the discharge outlet.
Procedure for adjusting the driving depth by modifying the contact arm.
Step-by-step instructions for safely removing jammed staples.
Troubleshooting and repairs should only be performed by authorized distributors or specialists.
