2。
KEEP
HANDS AND BODY AWAY FROM THE DIS.
CHARGE
OUTLET
\Mren loading and using the
tool, never
place
a hand or any
part
of body
in fastener discharge area of the tool. lt is very
dangerous to hit the hands or body by mistake.
DO
NOT
USE ON
SCAFFOLDINGS
AND LADDERS
Do not use on scaffoldings
and ladders with fastener
driving
tools equipped
with contact actuation
or continuous contad
actuation.
SAFETY
WARNING
DO NOT USE ANY
POWER
SOURCE
EXCEPT
AN AIR
COMPRESSOR
The tool is designed
to operate on compressed
air. Do not
operate the tool on any
other highpressure
gas,
combusti-
ble
gases
(e.9.,
oxygen, acetylene,
etc.) since there
is the
danger of an
explosion. For this reason, absolutely
do not
use anything
other than an
air compressor to operate
the
tool.
5-
^
10
^.loj
,f:ff.,> ZR
//- r
,\\
r/: r
/\\
It \l \\
(- v
:ll
ll-o I
ro-lf
\E
l'
\'y'
OPERATE
WITHIN THE
PROPER AIR PRESSURE
RANGE
The
tool is designed
to operate within
an air
pressure
range
of 5
to 7 bar
(70
to 100
p.s.i.).
The
pressure
should
be adjusted
to the type of the
work be-
ing fastened. The
tool shall
never
be
operated when
the op-
erating
pressure
exceeds
8.3 bar
(120
p.s.i.).
Never connect
the tool to air
pressure
which
potentially
ex-
ceeds 13.8
bar
(200
p.s.i.)
as the
tool can burst.
DO
NOT
OPERATE
THE
TOOL NEAR A FI.AMMABLE
SUBSTANCE
Never operate
the tool near
a flammable substance
(e.9.,
thinner,
gasoline,
etc.).
Volatile fumes from these
substanc-
es could be drawn
into the compressor
and compressed
to-
gether
with the air and
this could result in an
explosion.
NEVER USE
THE TOOL
IN AN EXPLOSIVE
ATMOS-
PHERE
Sparks
from the tool may
ignite atmospheric
gases,
dust or
olher
combustible materials.
DO NOT USE
A WRONG HTNNGS
The
conneclor on the tool
must not hold
pressure
when air
supply is disconnected.
lf a wrong
fitting is used, the
tool
can
remain charged with
air after disconnecling and
thus
will
be able to drive a
fastener even after
the air line is
dis-
connected,
possibly
causing injury.
DISCONNECT
THE AIR SUPPLY
AND EMPTY
THE
MAGAZINE
WHEN THE
TOOL IS NOT IN USE
Always disconnec{
the air supply
from the tool and empty
the magazine
when operation
has been completed
or sus-
pended,
when
unattended,
moving to a
different work area,
adjusting,
disassembling,
or repairing
the tool, and when
clearing a
jammed
fastener.
INSPECT SCREW
TIGHTNESS
Loose
or improperly
installed
screws or bolts
cause acci-
dents and tool
damage
when the tool
is
put
into operation.
Inspect to confirm
that
all screws and bolts
are tight and
properly
installed
prior
to operating
the tool.
To Next Page
Loading...
Need help?
General
