27
◊ Unit installation
● Location
1. The air conditioner should be placed on a firm foundation to reduce
noise and vibrations. As for a safe and secure positioning, place the unit
on a smooth, level floor strong enough to support the unit.
2. The unit has casters to aid its displacement, but it should be rolled only
on smooth, flat surfaces. Use caution when rolling on carpet surfaces. Do
not attempt to roll the unit over objects.
3. The unit must be placed within the reach of a properly grounded
socket.
4. Never place any obstacles around the air inlets/outlets of the unit.
5. Allow at least 12 inches (50cm) of space from the wall for an efficient
air-conditioning.
min.
min.
● Installation in a double-hung sash window
1) Attach the guard combined above to the window panel
Push the insect guard net firmly to ensure that its four projections fit into
the holes in the window panel.
Projection
2. Cut the foam seal (adhesive type) to the proper length and attach
it to the window stool
Foam seal A
(adhesive typ
3. Attach the window panel slider kit to the window stool.
- If the inner width of the window is between 22" (559mm) and 24"
(609mm) inclusive.
Adjust the length of the window panel slider kit according to the width of
the window; shorten the adjustable panel window kit if the width of the
window is less than 22 inches/559cm.
Open the window sash and place the window panel slider kit on the
window stool.
Cut
1) Remove the adjustment panel from the window panel, and cut the
window panel to the same width as the window.
(2) Open the window sash and place the window panel on the window
stool.
(3) Secure the window panel to the window stool with 2 screws
.
Window pane
22"~ 24"
Window stool
- If the inner width of the window is between 24" (609mm) and 36.8"
(934mm) inclusive.
(1) Open the window sash and place the window panel on the window
stool.
(2) Slide the adjustment panel to fit the window frame width.
(3) Secure the window panel to the stool with 3 screws.
Adjustment panel
24"~36.8"
To Next Page
Loading...
