Need help?Do you have a question about the Maxell ANC1 and is the answer not in the manual?
General| Type | Over-Ear |
|---|---|
| Active Noise Cancellation | Yes |
| Driver Size | 40 mm |
| Frequency Response | 20 Hz - 20 kHz |
| Weight | 220g |
| Impedance | 32 ohms |
| Bluetooth | Yes |
| Wireless Range | 10m |
| Microphone | Yes |
| Foldable | Yes |
| Cable Length | 1.2m |
| Connector | 3.5 mm |
| Connectivity | Bluetooth, Wired |
Earbuds power on automatically when removed from the charging case.
Connect to "MAXELL TWS-ANC1" via smartphone's Bluetooth menu.
Earbuds automatically power off after 5 seconds in case or 5 minutes disconnected.
Long press right earbud (4s) to switch ANC/APT modes.
Long press left earbud (4s) to activate/deactivate Gaming Mode.
Long press both earbuds (10s) to turn the device on or off.
Double tap left earbud for volume down, right for volume up.
Long press either earbud (2s) to answer or end calls.
Short tap either earbud to play or pause music.
Triple tap either earbud to access Siri or Google Assistant.
Press right earbud (2s) for next track, left for previous track.
Long press both earbuds for 10 seconds until red indicators flash to power off.
Long press both earbuds for 3 seconds until white indicators flash to power on.
After reset, press both earbuds over 3 seconds until indicators light up.
Disconnect the earbuds from all paired Bluetooth devices first.
Manually power off earbuds by long pressing for 10 seconds.
Long press both earbuds for 10 seconds post power-off for reset.
Place earbuds in case for 5s, then remove for auto-pairing.
Do not use near heat, use specified accessories, refer servicing to qualified personnel.
Avoid excessive heat, immersion in fluids, disassembly, and listen at safe volumes.
Green light indicates >20% battery, Red light indicates <20% battery.
Red light indicates low battery, Green light indicates full charge.
Ensure earbuds and device are within range, charged, and try a factory reset.
Check for nearby metal objects or other materials interfering with Bluetooth.
Verify Bluetooth connection and ensure 1 second delay after connection for activation.
To Next Page
