Maxi-Cosi Aura - Vehicle Anchorage Fitting

12
WARNINGS
WARNING: CHILD RESTRAINTS MUST NOT BE ATTACHED TO UNSOUND METAL
OR TO WOOD, OR SYNTHETIC STRUCTURES. WHEN DRILLING THE 9 mm HOLE
DO NOT DRILL THROUGH FUEL LINES, FUEL TANKS, ELECTRICAL WIRING, OR
RADIO SPEAKERS. WEBBING STRAPS MUST BE PROTECTED FROM SHARP COR-
NERS AND EDGES.
THE ANCHOR FITTING MUST BE USED ONLY AS DESCRIBED ABOVE. IT MUST
NOT BE HOOKED ONTO ANY OTHER OBJECT.
VehicleAnchorageFitting
VEHICLE SEAT LOCATION
IMPROPER PLACEMENT OF THE SAFETY SEAT INCREASES THE RISK OF
SERIOUS INJURY OR DEATH.
SOME SEATING POSITIONS IN YOUR VEHICLE MAY NOT BE SAFE FOR THIS
SAFETY SEAT. SOME VEHICLES DO NOT HAVE ANY SEATING POSITIONS THAT
CAN BE USED SAFELY WITH THE SEAT. IF YOU ARE NOT SURE WHERE TO PLACE
THE BOOSTER SEAT IN YOUR VEHICLE, CONSULT YOUR VEHICLE’S OWNER’S
HANDBOOK.
WARNINGS
For sedans only
Drill a 9 mm diameter hole in the parcel shelf on the centre-line of the seating position
as shown in Figure 2 (as shown on pg 11). Install the anchor bolt as shown in Figure 3
(as shown on pg 11). It is recommended that this installation be carried out by a child
restraint tting station or licenced motor mechanic.
For vehicles other than sedans
In Australia, consult your nearest child restraint tting station or trafc authority for
vehicle inspection to nd the best, correct position for the placement of the upper
anchorage point, and for the correct attachment bolt length and use of spacers. In New
Zealand, consult the agent for the vehicle.
vehicle
information