16
I
Mico Plus
I
Maxi-Cosi
For sedans only
Drill a 9mm diameter hole in the parcel shelf on the centre-line of the seating position as
shown in Figure 2 (as shown on page 15). Install the anchor bolt as shown in Figure 3
(as shown on page 15). It is recommended that this installation be carried out by a child
restraint fitting station or licenced motor mechanic.
For vehicles other than sedans
In Australia, consult your nearest child restraint fitting station or trac authority for
vehicle inspection to find the best, correct position for the placement of the upper
anchorage point, and for the correct attachment bolt length and use of spacers. In New
Zealand, consult the agent for the vehicle.
Vehicle information
Upper anchorage fitting installation
CHILD RESTRAINTS MUST NOT BE ATTACHED TO UNSOUND METAL OR
TO WOOD, OR SYNTHETIC STRUCTURES. WHEN DRILLING THE
9mm HOLE DO NOT DRILL THROUGH FUEL LINES, FUEL TANKS,
ELECTRICAL WIRING, OR RADIO SPEAKERS. WEBBING STRAPS MUST BE
PROTECTED FROM SHARP CORNERS AND EDGES.
THE ANCHOR FITTING MUST BE USED ONLY AS DESCRIBED ABOVE. IT
MUST NOT BE HOOKED ONTO ANY OTHER OBJECT.
WARNINGS
To Next Page