Mico Plus
I
Maxi-Cosi
I
19
Vehicle information
Angle configuration for the seat
• Position seat ensuring that the angle is no greater
than 40˚ from horizontal plane. This position is
necessary for the even distribution of forces
during possible impact.
• Angular adjustment is achieved by adjusting
the base. Make sure the line indicator is level to
ground (refer to page 21).
• DO NOT install convertible child restraints excessively reclined,
ensure the angle is no greater than 40°.
• DO NOT adjust harness or tether strap hardware such that it sits too
close to the occupant.
• Ensure that correct seatbelt path is used and that the restraint is
installed in the correct direction for rearward-facing application. Refer
to page 31.
• DO NOT wrap baby in a blanket or swaddled as infant can be ejected
and killed in an accident.
• Ensure the harness ts the baby rmly.
• Ensure that any blanket or other covering may only be placed over the
harness after the harness is adjusted rmly.
• The infant’s legs and arms are not to be bound or wrapped together.
• Always adjust the height of the shoulder straps as the child grows.
WARNINGS
To Next Page