Maxi-Cosi Pria - Page 23

23
Rear Facing ModeRear Facing Mode ISOGO
Figure 11
Figure 9
Figure 10
Unclip the ISOGO connectors
Step 1. Open ISOGO storage
compartment door on the backrest
portion of the seat to reveal the
ISOGO connectors (Figure 7).
Step 2. Unclip the ISOGO connectors
from the storage rod by pushing the
buckle button (Figure 8).
Step 3. Remove the straps from the
storage location.
Step 4. Close the access door
(Figure 9).
Thread the ISOGO connectors
through the belt path
Step 1. Thread the ISOGO connectors
through each belt path opening so the
belt sits in the installation path (Figure
10 & 11).
Step 2. Centre the ISOGO straps so
that they sit evenly on either side of
the SMART Lock
®
, and the two ISOGO
connectors are positioned evenly on
either side of the seat (Figure 11).
This will make it easier to keep the
restraint centered when installing
intovehicle.
Figure 7
Figure 8