24
Figure 12
Figure 13
Rear Facing Mode Install using ISOGO (if fitted)
Attach ISOGO connectors
Step 1. Attach the lower connectors
on both sides. Listen for a ‘click!’
(Figure 12).
Step 2. Pull to check connection
(Figure 13).
click
Fully lengthen ISOGO
connector straps
Press and hold the ISOGO adjuster
release button and pull the connector
strap to fully lengthen. Repeat for the
other connector.
Locate the ISOFIX lower
anchorage points
Locate the low anchorage points.
You can nd these by looking for the
ISOFIX logo located on the vehicle
seat. Refer to your vehicle owner’s
manual for more information if
required.
Pull
Check
Connection
To Next Page
