46
Forward Facing Mode Install using ISOGO (if fitted)
Remove slack from top tether
Step 1. Remove slack only. Do not
over-tighten the top tether strap so that
the restraint lifts up off the vehicle seat
(Figure 18).
Step 2. Ensure there are no twists and
turns in the top tether strap and that the
adjuster is positioned facing outwards
(Figure 18).
Note: There will be a half twist in the top
tether strap between the adjuster and the
shell of the restraint, allowing the adjuster
to be positioned facing outwards.
Step 3. Roll up excess strap and store in the
pocket provided on the cover. (Figure 19).
IMPORTANT:
Always remove slack from top tether.
A loose top tether is dangerous.
Attach the top tether
tovehicle
Attach the top tether strap to the
upper anchorage point in the vehicle.
Tightening top tether
Pull the loose and to tighten top
tether; but not so that the restraint lifts
up off the vehicle seat (Figure 18).
Attach
Store
Strap
Pull to
remove
slack
Figure 19
Figure 18
CAUTION: CHILDREN CAN BE INJURED OR
RESTRAINTS AND TOP TETHER STRAP
DAMAGED BY UNSECURED CARGO IN A
COLLISION. SECURE OR REMOVE HAZARDOUS
CARGO BEFORE USING THIS CHILD
RESTRAINT
Always secure the loose end of the top tether strap to prevent it
hanging out of the car or being accessible by the child.
When not in use, fold hanging tether strap and place in storage
pocket provided.
Loosening the top tether
Step 1. Press top tether adjust button
(grey)
Step 2. Simultaneously, pull the tether
strap through the adjuster to loosen as
required.
To Next Page
