8
model no. 054-6810-8 | contact us 1-888-670-6682
• When operating the router, always hold the handles firmly with both hands.
Always ensure that your footing is secure when working.
• Be prepared for the reaction torque of the router, particularly if the cutter
becomes jammed in the workpiece.
• When a plunge-cutting operation is completed, release the handle to allow
the router to rise back to its initial position.
• Familiarize yourself with your working area, and be alert for possible hazards
that you may not hear due to the noise of the router.
• Allow sufficient run-down time for the cutter after turning the router off. Wait
for it to come to a complete stop before removing it from the workpiece.
• Never slow the router down with your hands.
• Do not touch the cutter immediately after operation. It may be extremely hot
and could burn you.
• Never stop the router by applying lateral pressure to the cutter.
• Do not force the router. It will do a better job if you allow it to work at its
intended speed.
• Avoid cutting nails and screws. Inspect timber before cutting, and remove all
nails and screws.
• In the event of an electrical or mechanical malfunction, switch the router off
immediately, and disconnect the power cord from the outlet.
• Only use router bits suitable for the no-load speed of the tool.
• Always use cutter bits that are designed for this router. Never use cutter bits
which are larger in diameter than the opening in the router base. Cutter bits
that have cutter diameters larger than the opening could cause possible loss of
control or create other hazardous condition that could cause serious personal
injury.
SAFETY GUIDELINES
To Next Page
Loading...
Need help?
General
