13
• Replacement parts – When servicing, use only identical replacement parts.
• Polarized plugs – This saw has a plug that looks like the one shown below:
• To reduce the risk of electrical shock, this saw has a polarized plug (one blade is wider
than the other). This plug will fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not change the plug in any way.
MOTOR SAFETY PROTECTION
IMPORTANT: To avoid motor damage, the motor should be blown out or vacuumed
frequently to keep sawdust from interfering with the motor ventilation.
• CONNECT this saw to a 120 V, 15 A circuit with a 15 A time-delay fuse or circuit
breaker. Using the wrong size fuse can damage the motor.
• If the motor won’t start, release the trigger switch immediately. UNPLUG THE SAW.
Check the saw blade to make sure it turns freely. If the blade is free, try to start the
saw again. If the motor still does not start, refer to the TROUBLESHOOTING GUIDE.
• If the tool suddenly stalls while cutting wood, release the trigger switch, unplug the
tool, and free the blade from the wood. The saw may now be started and the cut
finished.
• FUSES may “blow” or circuit breakers may trip frequently if:
- MOTOR is overloaded – overloading can occur if you feed too rapidly or make too
many start/stops in a short time.
SAFETY GUIDELINES
WARNING!
• Double insulation does not take the place of normal safety precautions
when operating this tool.
• To avoid electrocution:
- Use only identical replacement parts when servicing a tool with
double insulation. Servicing should be performed by a qualified
technician.
- Do not use power tools in wet or damp locations or expose them to
rain or snow.
To Next Page
Loading...
Need help?
General
