35
AVOID DIRECT EYE CONTACT
• All the adjustments for the operation of this
laser guide have been completed at
the factory.
• Laser beam is calibrated and set up to
project to the left of the blade.
• If you have any problem or question on the
laser guide, please call the toll-free helpline
at 1-888-670-6682.
• Laser Warning Label: Max. Output < 5 mW
Wavelength: 630–660 nm. Complies with
21 CFR 1040.10 and 1040.11. Class IIIa
Laser Product.
• Laser Aperture Label: AVOID EXPOSURE:
Laser radiation is emitted from this aperture.
WARNING!
• Do not remove the lock from the ON/OFF switch during any laser
adjustments.
• Laser radiated when laser guide is turned on. Avoid direct eye contact.
• All the adjustments for the operation of this machine have been
completed at the factory. Due to normal wear and use, some occasional
readjustments may be necessary.
• Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
• The use of optical instruments with this product will increase eye hazard.
• Do not attempt to repair or disassemble the laser. If unqualified persons
attempt to repair this laser product, serious injury may result. Any repair
required on this laser product should be performed by authorized service
centre personnel.
Fig. 27
Laser Warning Label
Laser Aperture Label
ADJUSTMENTS
Laser aperture
label
Laser warning
label
To Next Page
Loading...
Need help?
General
