34
model no. 055-6767-0 | contact us 1-888-670-6682
TURNING LASER GUIDE ON (Fig. 26)
• To turn laser on, press rocker switch (1) to
“I” position.
• To turn laser off, press rocker switch (1) to
“O” position.
NOTE: The laser switch is covered with a
transparent protecting cover (2).
ALIGNING THE LASER GUIDE
• The laser beam must always be correctly
aligned with the blade to ensure straight,
even cutting. Your tool is equipped with
the Laser Guide cutting guide using a
Class IIIa laser beam. The laser beam will
enable you to preview the saw blade path
on the stock to be cut before starting the
mitre saw. This laser guide is powered by
the transformed alternating current supply
directly through the power lead. The saw
must be connected to the power source
and the laser on/off switch must be turned
on for the laser line to show.
NOTE: All the adjustments for the operation
of this machine have been completed at the
factory.
ADJUSTMENTS
Fig. 26
WARNING!
• Do not remove the lock from the ON/OFF switch during any laser
adjustments.
1
2
To Next Page
Loading...
Need help?
General
