ENGLISH
LNB Power: Press LEFT/RIGHT to set the LNB power. Default is ‘13/18V’.
22kHz: Press Left/Right to switch on or off the 22kHz. Default is ‘auto’.
Toneburst: Select or disable toneburst command.
DiSEqC1.0: select the right DiSEqC port (up to 4) for the correct input.
DiSEqC1.1: select the right DiSEqC port (up to 16) for the correct input.
Motor: Press Left/Right to select DiSEqC 1.2 setting. Then Press OK to show the
menu to set the positions.
DiSEqC1.2: Move the motor to a right position to lock the signal.
Move Auto: Press LEFT/RIGHT to start to move West/East. It will be stopped
automatically when the signal is locked.
Move Continue: Press LEFT/RIGHT to start to move West/East. It will keep
moving until you stop it.
Move Step [1]: Press LEFT/RIGHT to move just a step.
Store Position: Store current position of motor.
Goto Position: Press LEFT/RIGHT to go to the position stored.
Goto Reference: Reset all the positions.
19
To Next Page
Loading...
Need help?
General
