ENGLISH
6.2 Satellite list
Add satellites: Press Red to add a new satellite, in which you must input an
unique longitude and edit the satellite's name.
Edit satellites: Press Green to edit the selected satellite.
Delete satellite: Press Yellow to delete the selected satellite. Press OK to confirm.
Single Satellite Scan: Press Blue to enter the channel search menu.
Scan Mode:
Press Left/Right to select between default or Network.
Network scan will searched by NIT table. Default scan will search for
channels from pre-programmed transponder list.
Crypted:
Press Left/Right to select ‘All Channels’ or ‘FTA Channels’. All
channels will search for free to air and crypted channels. FTA channels will
only search for free to air channels.
Service Type:
Press Left/Right to select ‘ALL’, ‘DTV’ or ‘Radio’. All will
search for both radio and tv channels, DTV will search for only tv channels
and Radio will search for only radio channels.
Press OK to start scanning with the above settings.
20
To Next Page
Loading...
Need help?
General
