Maxon M-KIT100 - Installing the Main Panels; Panel Preparation and Initial Connection; Connecting Additional Panels to Form L-Shape

Page 5 of 10 M-KIT100/101/102 Assembly Instrucons 181-03001
These instrucons must be followed exactly. Failure to follow these instrucons could damage the product or result in injury to persons using or
assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulng from failure to properly
assemble the product in accordance with these instrucons.
Maxon Furniture Inc. Customer Service: 1-800-876-4274
Installing the Panels
Slide/pry the Top Cap from each PLNR4236 1.
Panel, being careful not to damage the parts
(Figure 1).
CAUTION! The following steps may require
assistance to complete.
Posion the PLNR4236 Panels in their 2.
approximate installed placement and level by
turning the Glides on the boom of the Panel
Frame with a 1/2 inch wrench.
On one PLNR4236 Panel, insert one Straight 3.
Alignment Bracket into the notch located on
the PLNR4236 Panel’s edge at the boom of
the PLNR4236 Panel frame (Figure 2).
Place one PLNRCP42 Corner Post on top of 4.
the Straight Alignment Bracket.
Connect the PLNRCP42 Corner Post to the 5.
PLNR4236 Panel by sliding plasc I-Beam
Panel Connectors down the grooves in
between the PLNRCP42 Corner Post and the
PLNR4236 Panel’s edge (Figure 3).
TIP! Use 3 I-Beam Panel Connectors in
each groove.
Using wire cuers or snips, trim the excess 6.
I-Beam Panel Connector length so that the
grooves are completely lled and ush with
the PLNR4236 Panel frame top.
Place one PLNR4236 Panel against the 7.
PLNRCP42 Corner Post at a 90° angle from the
rst PLNR4236 Panel (creang an L-shape).
Insert one Angle Alignment Bracket (Figure 2 8.
& Figure 4) into the slots of the two PLNR4236
Panels being connected.
Tip! Use two slots near the boom to
help eliminate interference with future
accessory installaons.
Figure 1
Panel end
Top Cap
Figure 2
Figure 3
Figure 4
TOP VIEW
I-Beam Panel
Connectors
90
INTERIOR
ASSEMBLED VIEW
Angle
Alignment
Bracket
Corner
Post
Angle Alignment
Bracket
Straight Alignment
Bracket
Glide
PLNR4236
Panel
PLNR4236
Panel
I-Beam Panel Connectors
PLNRCP42
Corner Post