Maxon M-KIT100 - Installing Panel Trim and Caps

Page 7 of 10 M-KIT100/101/102 Assembly Instrucons 181-03001
These instrucons must be followed exactly. Failure to follow these instrucons could damage the product or result in injury to persons using or
assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulng from failure to properly
assemble the product in accordance with these instrucons.
Maxon Furniture Inc. Customer Service: 1-800-876-4274
Installing Panel Trim
Install metal Wedge Brackets at all panel-1.
to-corner-post connecons by inserng the
Wedge Bracket ange between the PLNR4236
Panel and the PLNRCP42 Corner Post (Figure
8).
TIP! Four Wedge Brackets will be
installed.
Install one Corner Post Cap onto the two 2.
PLNRCP42 Corner Posts (Figure 9.a).
TIP! Two Corner Post Caps will be
installed.
Install one End Cap into the two PLNR4236 3.
Return Panel Top Caps (Figure 9.b).
Snap the two Top Caps onto the two PLNR4236 4.
Return Panels.
TIP! The End Cap tab should t into the
Panel frame.
Install one Top Cap Spacer into the end of 5.
each of the other two Top Caps (Figure 9.a).
Snap the two Top Caps onto the two 6.
PLNR4236 Panels with the Spacer end next to
the PLNRCP42 Corner Posts.
Figure 8
TOP VIEW
Wedge
Brackets
End Cap
Spacer Cap
Corner
Post
Cap
PLNR4236
Return
Panel
PLNR4236
Return
Panel
End Cap
(2 places)
Wedge Bracket
(4 places)
Corner Post
Cap
(2 places)
Spacer Cap
(2 places)
Figure 9.b
Figure 9.a
Top Cap