Receiving CTCSS/DCS
Your PM100 may be set-up so that only calls with the radios
specified code will be heard. In normal operation, the
speaker will remain quiet until the correct CTCSS/DCS code
is received. The status LED will glow green, the loudspeaker
will open and the message will be heard.
TRANSMIT TIME OUT TIMER
If set-up, your radio will stop transmitting after a preset
period of time. An audible alert is heard at the end of the
period.
TX LOCK-OUT
The PM100 may be set-up to disable the transmitter when
the channel is Busy. If the PTT button is pressed, an audible
alert will sound and the status LED will flash yellow.
MONITOR/TONE DEFEAT
Your radio may be set-up to either allow or dis-allow
monitoring of a channel. Short presses of the Monitor button
will toggle the monitor mode on and off.
When on, the radio will continue to receive even if the signal
is very low. This may assist clarity if the radio is operating at
the limit of its range.
CHANGE CHANNEL
The PM100 can access a maximum of 4 channels. Turn the
channel control to the channel number on which you wish to
operate.
SCANNING & PRIORITY LOOKBACK
Note: Your radio may or may not be configured for scanning.
Please ask your Dealer or System Supervisor for specific
details.
What is scanning?
Your radio is switched into Scan mode by selecting the scan
channel (see Dealer/System Supervisor for details). When
scan commences, it cycles through a set of channels. It is
pre-programmed to stop at any busy channel. When activity
stops on this channel, the radio waits a pre-determined time
to allow you to respond. If you dont transmit, the radio will
then continue with the scan.
ENGLISH
9
To Next Page
Loading...
