Maxon RA-45 - Connect to WAYPOINT Wi-Fi and Test Webpage; Monitor Cellular Connection Status

Page 20 of 36 M-21-08 REV.B
Addendum A
23. Use a smartphone or tablet to connect to the Optio3 WAYPOINT Wi-Fi hotspot. Connect to the
Optio3 Waypoint Wi-Fi hotspot that matches Optio3 WAYPOINT serial number you are working
on. When you are connected, it will show “Connected without Internet.” You are now ready to
scan the small QR code labeled “Scan to run local tests.” If the QR code is difficult to scan, enter
http://192.170.4.1
directly into the web browser to access the local test webpage.
24. Select the link shown from scanning the QR code. It will open a webpage, as shown below.
25. When the webpage first opens, it will show the SITE STATUS as “Checking…”. When the SITE
STATUS shows the sites as “reachable,” the cellular connection is working correctly.
Note: Depending on the cellular coverage and position of the vehicle/antenna, the time to
connect will vary.
Connect to Optio3
Waypoint Wi-Fi Hotspot
Scan Optio3 Waypoint
small QR code.
“Scan to run local tests”
Cellular connection
working
Checking for
connection
Optio3 Waypoint Serial #