To Next PageTo Next PageHow to set the pressure relief valve on Maxon RA-45?
To address an incorrectly set pressure relief valve in Maxon Lifting Systems, first, remove the cap to access the slide 'OUT' / 'IN' relief valve and set it to 1800 psi. Then, set the main Lift relief valve to 2750 psi.
How to check hydraulic fluid level in Maxon RA-45 Lifting Systems?
To check the hydraulic fluid level in Maxon Lifting Systems, ensure the Liftgate platform is stowed. The top level of the fluid should be visible at 3-3/4” above the bottom of the reservoir.
General| Brand | Maxon |
|---|---|
| Model | RA-45 |
| Category | Lifting Systems |
| Language | English |
Reconnect battery power and check all switches and lights for correct operation.
Steps for attaching the Solar Box to the liftgate channel.
Guidance on routing solar panel Home Run cables (PV+ and PV-) into the Solar Box.
Procedure for routing and connecting WAYPOINT and Charge Controller wires to the Junction Box.
Steps for routing and connecting cables from the Solar Box to the Charge Controller.
Mark the WAYPOINT as ready, enter deployment notes, and complete the setup.
System wiring schematic for the Junction Box, control, indicators, and lights.
System wiring schematic detailing the pump assembly and lights.
System wiring schematic illustrating the battery assembly connections.
Troubleshooting steps for issues with platform movement, motor operation, and power.
Troubleshooting for valve shifting problems, low pump pressure, and roller bearing wear.
Troubleshooting for platform movement, cylinder flow control, and lighting system problems.
