Page 14 of 36 M-21-08 REV.B
5. Connect Charge Controller data wires to Optio3 WAYPOINT.
WHITE wire to BLUE wire and YELLOW wire to YELLOW wire.
6. Cut ring terminal ends off 3 ft long Charge Controller battery cables.
7. Route Charge Controller battery cables through rear grommets as shown. Connect fused B+
cable from Charge Controller to B+ battery cable. Connect B- cable from Charge Controller to B-
battery cable.
CUT RING TERMINALS
OFF END OF CABLE
CONNECT BATTERY CABLE
TO CHARGE CONTROLLER B+
CONNECT BATTERY CABLE
TO CHARGE CONTROLLER B-
OPTIO3 WAYPOINT CONNECTIONS
To Next Page
Loading...
