Page 15 of 36 M-21-08 REV.B
8. Follow MAX SOL installation instructions (M-20-17) only for mounting solar panel and routing
solar panel Home Run cables (PV+ and PV-) into Solar Box. All other MAX SOL connections are
covered in this Addendum. The solar panel Home Run cables will be routed in the Liftgate
Channel Guide to the Solar Box, as shown below.
9. Cut Home Run cables approximately 4” from the connector. Run solar panel Home Run cables
(PV+ and PV-) into Solar Box through the center cord grip holes as shown below. Insert cut end
of the cable through center cord grip and trim excess cable. Use the 8-gauge butt splices
provided to splice and heat shrink connector ends to trimmed Home Run cables.
SOLAR PANEL HOME RUN
CABLES FROM REAR OF TRAILER
TOP TWO HOLES OF THE
CENTER CORD GRIP.
CABLE GUIDE
To Next Page
Loading...
