11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
10
1. Check for correct clearances (FIGS. 10-1, 11-1, and 11-2)
on
vehicle to prevent interference between vehicle and Liftgate.
VEHICLE REQUIREMENTS
NOTE: Make sure vehicle is parked on level ground while preparing vehicle and
installing Liftgate.
NOTE: Dimensions are provided as reference for fi tting Liftgate to vehicle body.
NOTE: Maximum and Minimum Operating Bed Height for Standard Platforms:
• Maximum bed height for TE-25DC & TE-33 Liftgates on high bed vehicles is 54”
(unloaded). Minimum bed height is 42” (loaded).
• Maximum bed height for TE-25DC & TE-33 Liftgates on low bed vehicles is 44”
(unloaded). Minimum bed height varies with platform depth. See TE-25DC & TE-33
LOW BED CLEARANCES, FIG. 11-1.
• Maximum bed height for TEWR-25 & TEWR-33 walk ramp Liftgates is 54” (un-
loaded). Minimum bed height varies with platform depth. See TEWR-25DC &
TEWR-33 CLEARANCES, FIG. 11-2.
If swing door latches interfere with fi t of extension plate, do not install this Liftgate
on vehicle bodies equipped with swing open doors.
TE-25DC & TE-33 HIGH BED CLEARANCES
(54” TO 42” BED HEIGHT)
FIG. 10-1
54” MAX BED HEIGHT
42” MIN BED HEIGHT
13”
22-1/8”
23-1/2” TO 11-1/2”
32-11/16”
24-1/2”
12-5/8”
To Next Page
Loading...
