Maxon TE-25DC - Default Chapter; Table of Contents

TABLE OF CONTENTS
SUMMARY OF CHANGES: M-17-10, REVISION A ............................................................. 4
WARNINGS ........................................................................................................................... 5
SAFETY INSTRUCTIONS .................................................................................................... 6
NOTICE ................................................................................................................................. 6
STANDARD LIFTGATE COMPONENTS .............................................................................. 7
TE-25DC & TE-33 INSTALLATION PARTS BOXES ............................................................. 8
TE-25DC & TE-33 MANUALS & DECALS ............................................................................ 9
VEHICLE REQUIREMENTS ............................................................................................... 10
CENTER OF MASS ............................................................................................................ 16
STEP 1 - ATTACH EXTENSION PLATE TO VEHICLE ....................................................... 17
BOLT EXTENSION PLATE .................................................................................. 17
WELD EXTENSION PLATE (ALTERNATE METHOD) ........................................ 20
STEP 2 - WELD LIFTGATE TO VEHICLE .......................................................................... 22
STEP 3 - ATTACH OPTIONAL BATTERY BOX & FRAME TO VEHICLE (IF EQUIPPED) . 28
STEP 4 - RUN POWER CABLE .......................................................................................... 36
STEP 5 - CONNECT POWER CABLE ................................................................................ 38
STEP 6 - CONNECT GROUND CABLE ............................................................................. 40
STEP 7 - INSTALL CONTROL SWITCH ............................................................................. 41
STEP 8 - CHECKING HYDRAULIC FLUID ......................................................................... 43
STEP 9 - CONNECT POWER CABLE TO BATTERY ......................................................... 45
STEP 10 - REMOVE LOCKING BRACKETS & CHECK FOR INTERFERENCE ............... 46
STEP 11 - ADJUST PLATFORM OPENER ......................................................................... 51
STEP 12 - ADJUST PLATFORM (IF REQUIRED) .............................................................. 53
STEP 13 - FINISH WELDING LIFTGATE TO VEHICLE ..................................................... 55
STEP 14 - BOLT OPTIONAL STEPS TO EXTENSION PLATE ......................................... 56
STEP 15 - VEHICLE TAILLIGHT POSITIONING ............................................................... 60
ATTACH DECALS: TE-25DC & TE-33 ............................................................................... 61