11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
24
2. Make sure hoist
is not being set
up the incorrect
way (FIG. 24-2).
Place a “C”-
clamp on each
side of platform
as shown in FIG.
24-1. (Clamps prevent
hoist chain from slipping off
platform.) Place chain all
around platform (FIG. 24-1).
INCORRECT WAY TO HOIST LIFTGATE
FIG. 24-2
To prevent damage to the fl ipover, NEVER hoist the Liftgate by the
fl ipover as shown in the NO illustration. Hoist the Liftgate by the platform only
as shown in the YES illustration.
CAUTION
3. Hoist the Liftgate.
Then, place fl oor jack
under main frame
(FIG. 24-1). Jack the
Liftgate into position.
Make sure vehicle
fl oor is horizontal
and pins are lined up
(FIG. 24-1).
!
STEP 2 - WELD LIFTGATE TO VEHICLE - Continued
FLIPOVER
HOIST CHAIN
CORRECT WAY TO HOIST LIFTGATE
FIG. 24-1
To Next Page
Loading...
