Maxon TE-25DC - Page 58

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
58
4. Bolt the step support (Kit item)
to mounting channel (Kit item)
(FIG. 58-1).
BOLTING SUPPORT TO MOUNTING CHANNEL &
STEP (LH DUAL STEP & SUPPORT SHOWN)
FIG. 58-1
I-BEAM
(VEHICLE BODY)
5. Butt the fl at part of the mounting
channel against bottom of vehicle
rear sill and I-beams. Then, butt the
step support against back of the
step (FIG. 58-1).
LH STEP
STEP SUPPORT
MOUNTING
CHANNEL
LOCK NUT
(3 PLACES)
FLAT WASHER
(3 PLACES)
REAR SILL
6. Ensure slotted hole in the step sup-
port is lined up with the hole on the
step (FIG. 58-1). Then, bolt the sup-
port to step (FIG. 58-1). Torque the
lock nuts (FIG. 58-1) to 105 lb-ft.
1/2” X 3-1/2” LG.
FRAME BOLT
(2 PLACES)
1/2” X 1-1/2” LG
FRAME BOLT
STEP 14 - BOLT OPTIONAL STEPS TO
EXTENSION PLATE - Continued