11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
PAGE 13
5. Drive Platform Hinge Pin into correct position through the Platform Hinge Bracket with a
hammer and pin punch as shown in (FIG. 7). Line up the hole in the Platform Hinge Pin with
the hole in the Pin Collar. Install the roll pin through the Pin Collar until roll pin protrudes
equally from both sides of the collar (FIG. 7).
ROLL PIN
(INSTALLED)
6. Operate the Liftgate according to instructions in Operation Manual M-00-40 to make sure
it operates correctly.
.
FIG. 7
PLATFORM HINGE
BRACKET
PIN COLLAR
PLATFORM
HINGE PIN
To Next Page
Loading...
