Maxxus Multipress 10.1 - Page 25

41
33
41
38
10
58
40
9
9
9
10
40
58
10
33
38
41
9
41
9
38
9
10
6x
25
ENG
Assembly – Multipress
Assembly Step 11
Fix the end of the traction cable (58) (threaded retainer – not the looped end!) using a safety nut M10 (10)
and a washer Ø10 (9) to the left-hand guide frame with double roller (54).
Feed through the looped end of the traction cable (58) upwards through the hole in the connecting piece
between the left-hand guide pipe and the left-hand side frame.
Then feed the traction cable further on over the two rollers attached on the side of the left-hand guide frame.
Then pull the cable downwards and put it in the top roller of double roller (40).
Now bring traction cable (58) back upwards and x it onto the attachment loop on the left-hand side frame.
To do this use a hexagonal head screw M10x25 (33), two washers Ø10 (9) and a safety nut M10 (10).
Repeat this procedure on the right-hand side.
CAUTION:
Check that the cable on the threaded retainer is rmly screwed in with the three socket head screws.
To be on the safe side, screw the socket head screws up tight again!
2x Traction Cables (58) – Length 3.580 mm
2x Double Rollers (40)
Threaded Retainer Attachment Loop