Instruction Manual
5
LED & switch instructions
SYNC button and LED 0
For the initial sync, press the SYNC button on the Wireless Sensor DolphinBar itself
and on the bottom of your controller. You’ll find that the four blue LEDs found in the
controller and the LED 0 found in the Wireless Sensor DolphinBar will flash quickly. Once
the sync process is complete, the LED on the Wireless Sensor DolphinBar and your controller
will stay lit. LED 0 communicates the connection status in three ways:
LED 0 flashes slowly.
Unable to connect to the Wii Remote controller.
LED 0 stays lit.
Wii Remote connected successfully to the Wireless Sensor DolphinBar.
LED 0 flashes quickly.
The Wireless Sensor DolphinBar is looking for Wii Remotes to pair.
To Next Page
Loading...