9
Slide 7
Press
Fast Time Down Test
Fast Time Down Test
While any test or cycle is running in Service Mode, pressing
the Temperature key will advance the program to the next
cycle stage.
Refer to Technical Data Sheet for Detailed Instructions
Fast Time Down Test
While any test or cycle is running in Service Mode, pressing the Temperature key will
advance the program to the next cycle stage.
Cycle stages are located at key locations in the machine operation. As the program is advanced
it will index as follows: The end of each fill (the same as the beginning of a tumble session for
Wash, or Rinse); at the beginning of a drain session; at the beginning of a spin session (at this
position, check the water level, if over reset level, drain first before entering the spin function); at
the beginning of a fill session; at the beginning of Bleach fill; at the beginning of Fabric Softener
fill; and every 3 minutes during the tumble sessions (Wash, and Rinses).
¤
To Next Page
Loading...
