Maytag 27" - The Door Has Not Been Opened after Two Complete Wash; Open Door Lock Switch with Motor Running; Motor Tach Signal Exists Without Motor Running; Te Abnormal High;Low Temp or Ohm Resistance Seen

18
Diag.
Code
Description Trigger Action to be taken
15 Stuck Key
A key is sensed to be pressed more than
30 seconds, the key will be assumed to be
stuck
Display "E2". Go to "Membrane
Pad Check" Check connection of
keypad to control board. Replace
LED Board if necessary.
17
Door switch
was not
seen open
since the last
three final
spins
The door has not been opened after two
complete wash cycles. Door switch was not
seen open since the last two final spins
Will display "od" If door open
sensing, will cleared.
18
Detected
door lock
switch open
during cycle
when not
expected.
Open door lock switch with motor running.
Check for loose wire connections
Clear the diagnostic code and
recheck; if reoccurs, perform
Diagnostic Motor/Machine Control
Board test Check for
faulty motor relay on the machine
control board.
19-21 Not Used
22
Door switch
detected
open during
cycle (when
not paused).
Door switch is detected open and the door
locked switch is read as locked.
Go to "Door Lock Test"
Troubleshooting Section
23-24 Not Used
25
Motor tach
signal exists
without
motor
running.
Tach signal exists without torque command
or when not expected (Abnormal condition
only).
Displays " bE". Replace Machine
Control Board.
26-28 Not Used
29
Sump
thermistor
failure
(Optional)
Abnormal high/low temp or ohm resistance
seen
Displays " tE".
- Loose or pinched wires
- Bad sump thermistor
30-33 Not Used