20
REMOVING THE WASHER FROM SERVICE
Disconnecting the Washer
1. Disconnect the washer from electricity.
2. Turn off power at the main switch on the rear of the washer.
3. Shut off the water and steam to the washer.
4. Disconnect all water and steam inlets.
5. Insulate the external electric power inlet conductors.
6. Place an “Out of Service” sign on the washer.
7. Unscrew any nuts (bolts) that may be securing the washer
to the floor.
8. During transportation, follow the instructions under “Equipment
for Handling, Transport, and Storage” in the “Installation
Requirements” section.
9. If the washer will not be used again, gently remove the door with
the hinge.
Disposing of the Washer
Scrap according to local codes.
DIMENSIONS
(Soft-Mount Models)
Side View
10
C
E
D
7
9
B
Front View
To Next Page
Loading...
