MayTech MTSKR1905WF - VESC Voltage and Current Display; VESC Voltage and Current Data; VESC Temperature Display; VESC and Motor Temperature Data

Maytech Waterproof Remote Control User Manual_20191012 by Eric and Eileen
12
/
17
16.4 Voltage and Current display:
For both Esurf and Esk8 modes, the interface must be displayed after selecting【VESC】in【Speed Source】.
Data is obtained from the VESC via the UART port. The voltage shows the current value and the minimum
value after running. The current shows the current value and the maximum value after running.
16.5 VESC temperature and motor temperature display
For both Esurf and Esk8 modes, the interface must be displayed after selecting【VESC】in【Speed Source】.
Data is obtained from the VESC via the UART port. It shows the current value and the minimum value after
running.
Distance is calculated based on RPM detected by one motor phase wire and
showed in Mile.