Maytronics HeatMiser II - Troubleshooting

maintenance Troubleshooting
HeatMiser II Installation guide. © 2014, all rights reserved P a g e | 16
TROUBLE SHO O TING
Problem:
What to do:
The pool is not hot enough
 Make sure that the pump is circulating
appropriately and that pool water is flowing
through the solar collector.
 Make sure that the pump is shut off during
night or cold weather.
 Check that the solar collector meets your
pool volume heating demand.
 Put your pool cover on at night and
whenever the pool is not in use to prevent
heat loss.
 Make sure the collector is exposed to the
sun at least 6 hours per day.
Bubbles flow continuously out of the pool
water inlet.
 Check all connections for leaks and air
suction.
 Check and make sure that water flows
continuously through the pump and the solar
collector.
Leaking solar collector
 Fittings leaks - Check the 'O ring', make sure
it is in its place and not pinched. Strengthen
the Metal Hose Clamp around the Hose
Adapter Fitting.
 Absorber leaks - disable the leaking riser
tube according to the instructions on page 17.