Preface General information
HeatMiser II Installation guide. © 2014, all rights reserved P a g e | 6
UNPA CKING THE SOL AR COL LECTOR
Carefully remove the collector and all its components from the box. Before you begin,
make sure all parts detailed on page 7 are present.
TOOLS & EQU IPME NT RE QU IRED
The following items are not included with the product, but are required for a proper
assembly and operation:
- Flat head screwdriver
- Section of Hose to connect HeatMiser II to pool system
FAM ILIAR IZE Y OURSE LF WITH Y OUR S URRO UNDIN GS
Before you begin assembling, it is a good idea to know certain specifications about your
pool:
- How big is your pool?
- How many gallons of water does it hold?
- What type of connections does your pool require?
- What is the ideal location of the solar collector for the ultimate exposure to the sun?
CHOOS ING THE IDE AL P OSI TION
Your solar collector is designed to be installed on the ground next to your existing pump
and filter system. Locate a hard leveled surface. You will need to position the solar
collector at a safe distance away from the pool so it cannot be used by children as a step
to obtain access to the water. Make sure the place you have chosen is exposed to the sun
at least 6 daily hours. Avoid areas that might be shaded at different intervals of the day.
Use the supplied stand to angle the collector so it is facing the sun.
NOTE: HeatMiser II must be installed between the filter and the pool water inlet,
AFTER the water is filtered to prevent dirt and debris from clogging the riser tubes.
To Next Page
Loading...