Mazda 6 - Buzzer

15
6. Hold the outside of the round part of the back sensor and insert
the sensor into the hole slowly.
7. Pull up the sensor tab using a flathead screwdriver.
■ Buzzer installation
1. Affix double-sided adhesive tape to the buzzer.
2. Peel off the double-sided adhesive tape backing and secure the
rear buzzer to the body panel of the upper inside part of the
trunk side trim (driver’s side).
• Insert the sensor so that the sensor tab is facing upward.
• After installation, verify that the corner sensor and back
sensor are securely pressed to the bumper.
CAUTION
• Always remove dirt or oil because the adhesive strength of
the double-sided adhesive ta
p
e weakens.
CAUTION
Buzzer
Body panel
Vehicle front
• Always remove dirt or oil because the adhesive strength of
the double-sided adhesive tape weakens.
CAUTION
Sensor
Sensor hole
(Surface of the rear bumper)
Tab
Backside of the rear bumper
Top
Vehicle front
Sensor
③
②
①
④
Double-sided
Adhesive tape
Buzzer