Mazda 6 - Tie Wrap

20
■ Main harness and buzzer harness
1. Affix the mount bases to the body panel. (2 locations)
2. Secure the buzzer harness using tie wraps. (2 locations)
3. Secure the buzzer harness to the vehicle wiring harness at 3
locations using tie wraps.
4. Branch connect the main harness (R) for the BACK signal line
branch of the main harness to the RBCM④ (W/B) using an
electro-tap.
• Always remove dirt or oil because the adhesive strength of
the double-sided adhesive ta
p
e weakens.
CAUTION
Mount bases and tie wraps
Body panel
Buzzer harness
Vehicle front
Tie wrap
Vehicle wiring harness
Buzzer harness
Tie wraps
Vehicle front
• Connect an electro-tap to the indicated signal line
securely. Misconnection may cause a system or vehicle
malfunction.
• Wrap the electro-tap area using urethane tape to prevent
the occurrence of abnormal noise.
CAUTION
Electro tap
Firmly press
using pliers
Lock
Vehicle wiring
harness (W/B)
Main harness (R)
Electro tap
◆ Branch connection procedure using electro tap
Main harness (R)
Vehicle wiring
harness (W/B)
1. Insert the main harness (R) and vehicle wiring harness into the
electro tap.
2. Firmly press the electro tap terminal using pliers.
3. Fold the electro tap in the direction of the arrow shown in the
figure and lock it.
Electro tap
4S (W/B)
RBCM④ 18 pin connector
(View from harness side)
RBCM
Main harness (R)
Buzzer harness
Vehicle front
• Cut off the remaining part using nippers or a similar tool
when securin
g
usin
g
tie wra
p
s.
CAUTION
• Cut off the remaining part using nippers or a similar tool
when securin
g
usin
g
tie wra
p
s.
CAUTION