Mazda 6 - Page 19

19
■ Control unit installation
1. Affix double-sided adhesive tape to the control unit.
2. Connect the main harness, harness (short and long) and buzzer
harness connectors to the control unit.
3. Peel off the double-sided adhesive tape backing and adhere the
control unit to the body panel of the lower part inside of the
trunk side trim (driver’s side).
• Make sure the connector is securely pressed in until a click
sound is heard.
CAUTION
Control unit
Double-sided
adhesive tape
• Always remove dirt or oil because the adhesive strength of
the double-sided adhesive ta
p
e weakens.
CAUTION
• Always remove dirt or oil because the adhesive strength of
the double-sided adhesive ta
p
e weakens.
CAUTION
Control unit
Harness (long)
Main harness
Harness (short)
Buzzer harness
Control unit
Double-sided
adhesive tape
Body panel
Vehicle front