Mazda 6 - Harness (Long)

16
■ Harness (short and long)
1. Connect the harness (short and long) connector to the No.1,
No.2, No.3, No.4 sensor.
2. Remove the electrical tape wrapped around the hole cover.
3. Remove the hole cover and set it inside the vehicle using
needle-nose pliers.
8．WIRING HARNESS
OK
NG
Harness (short)
Sensor
Cover
Cover
Sensor
Sensor
Harness (long)
Hole Cover
Vehicle front
• Make sure the connector is securely pressed in until a click
sound is heard.
CAUTION
Hole Cover
Electrical vinyl tape