Date , ,
VIN.
Approved
Checked
Person in
charge
INSTALLATION
INSPECTION
SHEET
MAZDA6
PARKING SENSOR, REAR
C853
V7 290 (PARKING SENSOR, REAR)
C844 V7 281 (4pc. SENSOR)
Perform the following inspections
1. Inspection items after installation
• Verify the fitting between the vehicle part and the installed part, and inspect for damage or dirt.
• When connecting connectors, verify the connection again to prevent poor connection or mis-connection.
(Insert two times.)
2. Vehicle parts reinstallation
Inspection Parts
Inspection Items
Inspection Check
Negative battery cable
Torque check
Are the battery cables securely tightened to the
terminals?
Rear combination light
Turn on/off
Is the turn light illuminated?
Are the brake lights illuminated?
Are the back-up lights illuminated?
Function restore procedure
after removal/installation of
battery
Operation check
Have the vehicle’s functions been restored by referring to
“Required servicing after disconnecting/connecting
negative battery cable”, in the vehicle workshop manual
or the owner's manual?
Check
Check
※ The term of validity for this sheet: 3 Years
― Continued backside ―
• Before starting the engine, make sure there are no persons in front of or behind the vehicle, or around the engine
compartment. Otherwise a serious accident could result by the vehicle suddenly moving.
• Do not start the engine in a place such as a garage or other location with poor air ventilation. Otherwise,
poisoning or asphyxiation could result from accumulation of exhaust gas.
• Always set the wheel blocks on level ground before performing the verification.
WARNING
To Next Page
