Mazda CX-30 - Page 276

▼
Setting the System
The MRCC with Stop & Go function system operates when all of the following
conditions are met.

Vehicle speed is 0 km/h (0 mph) to 145 km/h (90 mph)

The MRCC with Stop & Go function is turned on.

The brake pedal is not depressed.

The parking brake is released (Electric Parking Brake (EPB) indicator light is turned
o).

There is no problem with the DSC.

All the doors are closed.

The driver's seat belt is fastened.

The selector lever is in the drive (D) position or manual (M) position (manual
mode).
NOTE

In the following cases, the MRCC with Stop & Go function system is canceled
when the vehicle is traveling at 30 km/h (20 mph) or less and “Mazda Radar
Cruise Control Disabled Under 30 km/h” is displayed in the multi-information
display.

The Forward Sensing Camera (FSC) cannot detect target objects (There is
problem with the Forward Sensing Camera (FSC) or windshield is dirty).

There is a problem with the stop hold control function.

There is a problem with the Electric Parking Brake (EPB).

It may not be possible to set the MRCC with Stop & Go function system directly
after starting the engine, while the DSC operation is being checked.
Turning on the system
1. CANCEL switch
2. RES switch
3. MRCC switch
When Driving
i-ACTIVSENSE
4-132
CX30_8JP5-EA20K_Edition1_new 2020-7-22 15:50:09