Branching connection using electro-tap (ON-OFF switch harness)
1. Put the vehicle harness to be branch-connected into the guide
groove.
2. Fold back the electro-tap from the A part as shown in the figure.
3. Lock the electro-tap temporarily.
4. With the nose surfaces of a pair of pliers, pinch the center of
the electro-tap so that the force is applied evenly across the
electro-tap, and engage the final locks on the both sides.
Cautions on use of electro-tap
(1). The electro-tap can be used without problem even if the A part
is broken. You can use it as it is.
(2) When removing this accessory, do not disassemble the
electro-tap, but cut the wire for the accessory leaving about 30
mm of it, and wrap it together with the vehicle harness with
electrical tape for insulation.
Guide groove
Vehicle harness
䌁
Terminal
Insulator
x The terminal is embedded in the insulator. If it is not, insert
the terminal as shown in the figure and press it in until it is
securel
fixed.
CAUTION
Temporary lock
Final lock
x The temporary lock is provided on only one side. Stop short
of locking the final locks.
CAUTION
Use pliers with jaws widened
Kit harness
Electrical vinyl tape
Vehicle harness
䌁
x Do not reuse a used electro-tap.
CAUTION
x Pinch the electro-tap until a clicking sound is heard from the
final locks on the both sides.
CAUTION
To Next Page
Loading...
