- 9 -
Trowels equipped with the MBW Power Pitch handle
system may periodically need adjustment to
achieve full range of blade pitch angle.
1. Place trowel on a flat surface and extend actuator
fully.
2. Loosen, but do not remove, clamping nut (12) from
upper actuator mount (7).
3. Slide upper actuator mount rear and upward in slot of
support bracket (5) until resistance is met, Then
tighten bolt (14) in end of bracket to hold in place.
4. Tighten clamping nut (12).
5. Run actuator through entire stroke to ensure proper
operation.
To Next Page
Loading...
